• Dynagear

Dynagear

In the Fluid Power industry OEM Dynamics is regarded as being among the most competent innovators in the interfacing of hydraulic pumps to diesel engines for mobile and stationary equipment. Dynagear products include a wide range of splined hubs, couplings, shafts and sleeves as well as flexible couplings, diesel engines drives, agricultural gearboxes, driveline components and overhung load adaptors. Other Mechanical Power Transmission products including bevel drive gearboxes, worm drives, parallel shaft drives and mechanical and air clutches.

The Clamplock range is an Australian designed and made spline locking mechanism which is incorporated in our gear type couplings, splined universal joint yokes and splined driveline companion flange.


These products are Australian made and produced at our factory in Ballina NSW.

Splined Components

• Splined hubs
• Couplings
• Shafting
• Stubwelds
• Slipsleeves

Available ex-stock. Components can also be manufactured to customer requirements.

Flexilock Single Pump Drives

Pre-engineered single pump drives now available in four power sizes. With over 300 combinations we offer the largest standard range of direct drive kits for diesel engines. These drives utilise the clamplock spline locking mechanism and our special polymer element is formulated for optimum elasticity at engine operating temperatures to absorb engine torsional vibrations over a long cycle life. 

HDC and LDA Overhung Load Adaptors

Model HDC - This model may be supplied to suit SAE ‘A’, SAE ‘B’ or SAE ‘C’ hydraulic pump motor interfacing and 12 shaft size options accommodating almost any SAE Hyd motor up to SAE “C”.

Model LDA - this is a low cost model with fixed SAE “A” motor adaptor and 7 shaft size options.

Flexilock Couplings

Developed for hydraulic pumps, includes most splined and round bore shaft connections. Feature a large gear tooth form with wide face contact between the steel gear and polymer element giving high power capacity in a small unit. 

Disconnects 

Used where a hydraulic pump requires disengaging when not in use. Available in clockwise or anticlockwise versions. Supplied to suit SAE ‘A’, ‘B’ or ‘C’ hydraulic pump or motors or as a shaft to shaft version. 

Tractor PTO Hydraulic Pump Drives

These drives were developed for use as directly driven hydraulic pump speed increasers. Maximum power is 50 horsepower at 540 RPM Horsepower at 1000 RPM input for the 2.04 ratio model . The T33 is available to accept most SAE “A”, SAE “B” or SAE “C” hydraulic pumps. Male shaft models are available for implement mounting. 

We are specialists in the manufacture & servicing of Power Transmission and Heat Transfer products.

We offer solutions from minor repairs through to complete overhauls.

Contact us for a quote
Products to compare:
Comparing Products